Easy DIY Roman Shade

Lately I have been seeing roman shades in a lot of design articles.  I wanted to attempt one for our kitchen door to increase the privacy if we want it (especially because the kitchen door is right outside the bathroom door).  This is a short tutorial to DIY a roman shade for a door.

You will need about 3 yards of fabric (which left enough for a cafe curtain on our kitchen window), seam tape, fabric glue, and a cheap set of blinds.

Start by making your fabric the right size to fit the blinds.  I measured the blinds, then added 4 inches to the dimensions.  This allowed and inch and a half for the seams on each side and a bit of overhang left over.

Use the seam tape (or sew) the edges of the fabric to create a large rectangle.

DIY Roman Shade Seam Tape

DIY Roman Shade Seam

 

Next, lay out the blinds on top of the fabric.  The front of the blinds should face the fabric.

DIY Roman Shade Layout

 

It is easiest to glue the top  edge of the blinds down at this point.  The glue will be applied to the edge with the pull cord and laid on top of the fabric.

DIY Roman Shade Glue DIY Roman Shade Top

 

In order to remove the extra slats, you will need to cut the smaller cord that holds them together.  Do not cut the thick pull cord.

DIY Roman Shade Cord

 

Remove the plugs at the bottom of the blinds and untie the pull cord.

DIY Roman Shade Bottom

 

You can now remove the bottom and extra slats.  I placed my slats about 8 inches apart, which left 8 plus my top and bottom.

DIY Roman Shade Spacing

 

Glue each slat down with fabric tape an equal distance apart.  You can choose any number of slats and the distance based on the look you want to achieve.

Once the slats are glued, you need to put the bottom piece back on and tie a new knot to hold it in place.  Then replace the plastic plugs.

DIY Roman Shade Bottom Cord

 

Lastly, the fabric needs to be glued to the bottom piece.  Just apply the fabric glue and wrap the fabric around.

DIY Roman Shade Fabric Bottom

 

Let the glue dry overnight and then hang your curtain following the instructions that came with the blinds.

DIY Roman Shade for a Door

 

That’s all that it takes!  Cutting the fabric to size was the longest part of this project, but it was pretty simple overall.  You can also use this on any window blind by adjusting the number of slats.

Thanks for reading!

Please follow and like us:

4 Replies to “Easy DIY Roman Shade”

  1. Very good descriptive article on the introduction of doors of Roman shades design. These designs are really impressive and would definitely suit our house. It also adds charm to the looks of our beautiful house. Really great article.

  2. I know this post has been up awhile, but I wanted to say thanks! I found this on Pinterest and made Roman shades this weekend! I used a canvas drop cloth so the cutting was a little easier! This is a fabulous tutorial! Thanks for saving me from paying over $100 a shade for custom ones!!

    1. I have been looking for a custom roman shade for the door out to my patio and I am wanting to attempt this, but before I go out and spend the time and money for this project, are there any issues in completing this outside of what is explained in the tutorial?

Comments are closed.